Zoning Standards for the RR-40: Rural Residential District
The RR-40: Rural Residential District in the City of Concord allows for rural single-family residential development with a maximum lot coverage of 20 percent for single-family residences. While specific Floor Area Ratio (FAR) limits are not explicitly defined for RR-40 single-family residential dwellings in the development tables, the district is designated for low-intensity use with a maximum density of 2.5 dwelling units per net acre.
Zoning District Overview
The RR – Rural Residential district is applied to areas of the City of Concord appropriate for rural single-family residential development or clustered development at densities up to two and one-half units per net acre [Section 18.30.010]. The RR-40 designator specifically denotes a minimum lot size of 40,000 square feet [Section 18.30.010].
Development Standards for RR-40
The following table outlines the key development standards for the RR-40: Rural Residential district as established by the City of Concord.
| Standard | RR-40 Requirement |
|---|---|
| Density (minimum/maximum) | 0 – 2.5 dwelling units per net acre |
| Lot Area (minimum) | 40,000 square feet |
| Lot Width (minimum) | 150 feet (Single-Family) |
| Lot Depth (minimum) | 100 feet (Single-Family) |
| Lot Coverage (maximum) | 20 percent (Single-Family) |
| Building Height (maximum) | 30 feet (Single-Family) |
Note: For nonresidential development, lot coverage and building height shall be established in compliance with the requirements specified by the applicable permit [Section 18.30.030].
Setback Requirements
The minimum setback requirements for single-family residences in the RR-40: Rural Residential district are as follows:
| Setback Type | RR-40 Requirement |
|---|---|
| Front | 30 feet |
| Interior Side | 10 feet |
| Aggregate Side | 50 feet |
| Corner Side | 25 feet |
| Rear | 50 feet |
Note: In no case shall any structure be erected closer than 50 feet from the centerline of any street in the RR-40 district [Section 18.30.030].
Sections Cited
- Section 18.30.010: Purpose
- Section 18.30.030: Table 18.30.030 – RR and RS districts – Development standards