Zoning Standards for RS-7.5 Single-Family Residential District in Concord
The RS-7.5 Single-Family Residential district in Concord requires a minimum lot area of 7,500 square feet, a minimum lot width of 75 feet, and a minimum lot depth of 85 feet for single-family residential development. These standards are established to guide low-density residential neighborhood development within the City of Concord.
Minimum Lot Dimensions for RS-7.5
In the City of Concord, the RS-7.5 Single-Family Residential district is classified as a "Low Density" residential zone [Section 18.15.020]. The development standards for the RS-7.5 district regarding lot size and dimensions for single-family residential uses are detailed in the following table:
| Standard | Requirement for RS-7.5 |
|---|---|
| Minimum Lot Area | 7,500 square feet |
| Minimum Lot Width | 75 feet |
| Minimum Lot Depth | 85 feet |
[Section 18.30.030]
General Development Standards
All new uses, structures, and alterations in the RS-7.5 district must comply with the development standards specified in the Concord Municipal Code. These standards ensure that development is consistent with the City of Concord General Plan [Section 18.30.030].
- Lot Coverage: The maximum lot coverage for a single-family residence in the RS-7.5 district is 35 percent [Section 18.30.030].
- Building Height: The maximum height for a single-family structure in the RS-7.5 district is 30 feet [Section 18.30.030].
- Setbacks: For single-family residential structures in the RS-7.5 district, the minimum setback requirements are as follows:
- Front: 20 feet
- Interior Side: 5 to 10 feet
- Aggregate Side: 15 feet
- Corner Side: 10 feet
- Rear: 20 feet
[Section 18.30.030]
Applicability and Exceptions
The RS-7.5 district is applied to areas appropriate for single-family residential uses with densities ranging from 2.5 to 10 units per net acre [Section 18.30.010].
Compliance with these standards is required for all new subdivisions, new uses, and alterations to existing structures. Additional requirements may apply pursuant to the broader Development Standards (Division IV) and Standards for Specific Uses (Division V) of the Concord Municipal Code [Section 18.30.030].
Sections Cited
- Section 18.15.020: Zoning map and districts
- Section 18.30.010: Purpose
- Section 18.30.030: Table 18.30.030 – RR and RS districts – Development standards