Minimum Lot Size and Dimensions in the West Concord Mixed-Use (WMX) District

The West Concord Mixed-Use (WMX) district requires a minimum lot area of 25,000 square feet for development. Additionally, the WMX district mandates a minimum lot width of 100 feet and a minimum lot depth of 100 feet.

Lot Size and Dimension Standards

In the West Concord Mixed-Use (WMX) district, all subdivisions, new uses, and structures must comply with the development standards specified in Table 18.45.030. The following table summarizes the minimum lot requirements for the WMX district:

Standard	WMX District Requirement
Minimum Lot Area	25,000 square feet
Minimum Lot Width	100 feet
Minimum Lot Depth	100 feet

Note: Development on sites with less than the minimum lot size in the WMX district requires a use permit [Section 18.45.030].

Additional Development Regulations

While the WMX district establishes minimum dimensions for lots, the following regulations also apply to development within this zone:

• Maximum Floor Area Ratio (FAR): The maximum FAR permitted in the West Concord Mixed-Use (WMX) district is 4.0 [Section 18.45.030, Table 18.45.030].
• Residential Use: The WMX district does not allow residential uses [Section 18.45.010].
• Building Height: The maximum building height in the WMX district is 140 feet [Section 18.45.030, Table 18.45.030].
• Setbacks: Required minimum setbacks in the WMX district are as follows [Section 18.45.030, Table 18.45.030]:
  • Front: 10 feet
  • Interior Side: 10 feet
  • Corner Side: 10 feet
  • Rear: 0 feet

Sections Cited

• Section 18.45.010: Purpose (Downtown Districts)
• Section 18.45.030: Table 18.45.030 – Downtown districts – Development standards