Development Standards for the Service Commercial (SC) District in Concord
The Service Commercial (SC) district in the City of Concord allows a maximum Floor Area Ratio (FAR) of 0.8. Lot coverage for nonresidential developments in the Service Commercial (SC) district is established through the permit process, ensuring development aligns with the surrounding district regulations.
Development Standards for the Service Commercial (SC) District
The Service Commercial (SC) district is intended to accommodate a variety of commercial uses, including automobile services, light industrial activities, and contractors' yards [Section 18.40.010]. Development within the Service Commercial (SC) district must comply with the general development standards and the specific intensity limits set forth by the Concord Development Code.
Intensity and Lot Standards
The following table summarizes the primary development standards applicable to the Service Commercial (SC) district:
| Standard | Service Commercial (SC) Requirement |
|---|---|
| Floor Area Ratio (FAR) (Maximum) | 0.8 |
| Lot Area (Square Feet) (Minimum) | 10,000 |
| Lot Width (Feet) (Minimum) | 100 |
| Lot Depth (Feet) (Minimum) | 100 |
| Building Height (Feet) (Maximum) | 35 |
Note: Reduced dimensions for lot width and depth may be allowed in the Service Commercial (SC) district subject to use permit approval [Section 18.40.030].
Lot Coverage Regulations
In the Service Commercial (SC) district, the specific lot coverage is not defined by a singular percentage in the general standards table. Instead, lot coverage for nonresidential developments in the Service Commercial (SC) district is established in compliance with the requirements specified by the applicable permit [Section 18.40.030]. If a permit is not required for a specific project, the regulations of the abutting district shall apply to each adjacent portion of the property.
Setback Requirements
For nonresidential developments in the Service Commercial (SC) district, the setback standards are as follows:
| Setback Type | Service Commercial (SC) Requirement |
|---|---|
| Front Setback | 15 feet |
| Corner Side Setback | 10 feet |
| Interior Side/Rear Setback | None required (unless adjacent to an R district or residential use) |
Note: Reduced setbacks in the Service Commercial (SC) district may be allowed subject to use permit approval [Section 18.40.030].
Sections Cited
- Section 18.40.010: Purpose
- Section 18.40.030: Table 18.40.030 – Office and commercial districts – Development standards