Building Height and Development Standards for the RS-8 Residential District
The RS-8 Residential Single-Family District in the City of Concord allows for a maximum building height of 30 feet for single-family structures. This district is part of the broader Single-Family Residential zoning category, which typically accommodates low-density residential uses at a density of 2.5 to 10 dwelling units per net acre.
Height and Development Standards in the RS-8 District
In the RS-8 Single-Family Residential District, the maximum building height for single-family structures is 30 feet, as measured from the ground level directly below the highest point of the structure [Section 18.30.030].
The following development standards apply to the RS-8 district:
| Standard | RS-8 Requirement |
|---|---|
| Maximum Building Height | 30 feet |
| Minimum Lot Area | 8,000 square feet |
| Minimum Lot Width | 80 feet |
| Minimum Lot Depth | 85 feet |
| Maximum Lot Coverage | 35 percent |
Setback Requirements for RS-8 Single-Family Residential
The following minimum setback standards apply to single-family structures in the RS-8 district [Section 18.30.030]:
| Setback Type | RS-8 Minimum |
|---|---|
| Front | 20 feet |
| Interior Side | 5, 10 feet |
| Aggregate Side | 15 feet |
| Corner Side | 10 feet |
| Rear | 20 feet |
Note: Measurements for setbacks are determined from the property line or the back of the sidewalk, whichever is less, to the face of the building or structure [Section 18.30.030].
General Development Provisions
All development within the RS-8 district must comply with the general development standards established in the Concord Development Code. This includes provisions for fence and wall heights, which generally may not exceed six feet in residential districts, with specific height exceptions available for side or rear yard setbacks under defined conditions [Section 18.150.040]. Additionally, all new development must ensure compliance with parking requirements and landscaping standards as prescribed in the code [Section 18.160.040; Section 18.165.050].
Sections Cited
- Section 18.30.030: RR and RS districts – Development standards
- Section 18.150.040: Fences and walls
- Section 18.160.040: Parking requirements
- Section 18.165.050: Landscape requirements